Below-knee amputees' mobility: can a cushion liner, manufactured with 3D-printing enabled technology, improve the prosthetic experience?

Abstract

Abstract:

Introduction: Prosthetic silicone liners improve comfort and skin protection and allow the use of total surface bearing (TSB) sockets, which provide enhanced proprioception and comfort. Unfortunately, silicone liners are cost-prohibitive in resource-limited environments (RLEs) where patellar tendon bearing (PTB) sockets with PE-lite liners remain standard, leading to patient discomfort and skin issues.

Objective: This study evaluates the benefits and durability of an affordable silicone liner locally manufactured in an RLE to promote TSB socket adoption, aiming to enhance prosthetic care and patient outcomes.

Methods: Ethical approval was granted by the Nepal Health Research Council. Twelve people with a unilateral transtibial amputation who were using a PTB socket with PE-lite participated in the study and received a new prosthesis (TSB socket with an affordable silicone liner). Participants performed mobility tests (2-Minute Walking Test, Timed Up and Go Test) and completed self-reported questionnaires for both prostheses. Liner durability was assessed.

Results: Participant mobility improved while wearing the TSB socket and silicone liner. The new prosthesis was found to be comfortable, and there were no major problems identified although excessive sweating, typical with silicone liners, was reported. Liners were replaced after 6.1 (63.1) months.

Conclusion: A locally manufactured liner provided increased mobility and high levels of satisfaction. This affordable liner may be suitable for use in RLEs, enabling adoption of TSB sockets and improving rehabilitation outcomes of people with a transtibial amputation. However, durability concerns and excessive sweating would suggest that improvements can still be made. Keywords prosthetic care, silicone liners, resource-limited environments, below-knee amputation, mobility, transtibial Date received: 5 June 2024; accepted 21 November 2024